REZINA.UZ
ELASTIK FORM
From idea to finished part.
How to Properly Measure Rubber Products for Ordering

How to Properly Measure Rubber Products for Ordering

Article

Accurate dimensions ensure the ordered product fits perfectly. Here's how to measure correctly.

For rings: 3 measurements needed — inner diameter (d), outer diameter (D), cross-section thickness (h). Use calipers, don't stretch.

For cuffs: inner diameter, outer diameter, height and lip type. Indicate pressure direction.

For gaskets: thickness, all dimensions, hole positions and diameters. Best — attach a photo with ruler or calipers.

For bushings: inner diameter, outer diameter, length. For rubber-metal — specify metal bushing dimensions separately.

Common mistakes: measuring stretched product, measuring worn product without accounting for wear, missing tolerances.

Tip: if product is heavily worn, measure the seat (groove, channel, shaft) instead. More accurate.

No calipers? Bring the sample to our factory. We'll measure free and suggest the optimal solution. WhatsApp.

Do not treat a worn lip as nominal. Measure housing grooves and landings, then compare with remaining rubber — otherwise you copy a dead profile.

Rings need ID, OD and section at two points; ovality after compression is common. Cuffs need rod/bore diameters and groove height.

A photo without a scale in the part’s plane is almost useless. The ruler must sit on the rubber.

If the part is torn, send all fragments and a photo of the joint.

Related products
Need consultation?

Write to us — we'll help select material and calculate cost

Other articles