EPDM is recommended for steam and water at the gas complexes up to +150 °C. FKM or PTFE for gas and hot condensate that carries hydrocarbons. Made in Tashkent. Delivery to Karshi in 1-2 days.
EPDM — steam and hot water resistantViton / FKM — up to +250°C, chemical resistantSilicone — electrical insulation and heat resistantNBR — for oil cooling systemsPTFE — for aggressive media
Products for industry
Steam and gas turbine seals
Plate heat exchanger gaskets
Vibration mounts for generators
Cable entries and seals
Pipeline flange gaskets
Pump equipment dampers
Advantages
✓Operating temperatures up to +250°C
✓Steam, oil and chemical resistant
✓Electrical insulation properties
✓Replacement of Siemens, ABB seals
✓Urgent production — minimize plant downtime
TashkentPlant
yesDrawing or sample
3–5 daysLead time
Delivery to Karshi in 1-2 daysDispatch
What we make
Heat-exchanger and flange gaskets
Valve rings
Pump shaft seals
Sheets cut to size
Material recommendation
EPDM — water and steam up to +150 °C
FKM — if the joint has oil and the temperature is above the EPDM limit
NBR — oil pumps. For the steam line — EPDM
What to include in a request
A drawing, dimensioned sketch or worn sample of the part.
The working medium, temperature, pressure and duty cycle.
Seat dimensions if the seal works in a groove, on a shaft or rod.
Quantity and the date the batch is required.
Selection and limits
The grade follows medium, temperature and load; colour or a name on old rubber does not prove its compound.
Dimensions and tolerances are agreed before launch; worn samples are checked against the seat as well.
Rubber bladders, pneumatic chambers, bladder compensators and large molded parts are not manufactured.
